G1110

Alloy Steel

G1110

UNS G-series alloy steel G1110

Chemical Composition (%)

C0.1
MN0.6
S0.08
P0.04

Applications

Carbon / low-alloy engineering steel per SAE-AISI UNS system.

Available Forms

Bar, plate, sheet, tube, forgings, strip, wire

Uses

Low-carbon grade used for welded structures, shafts, pins, bolts, nuts, seamless tubes and general engineering components where moderate strength and good weldability are required. Commonly supplied as bar, plate, sheet, tube and forging.

Heat Treatment

Typically normalized (880–920 °C, air cool) or carburized (900–930 °C) for case-hardening grades, then quenched and tempered at 150–200 °C.

Precautions

Weldable with standard procedures; preheat may be needed for thick sections or higher-carbon/ alloy grades. Protect from decarburization during heating (controlled atmosphere or protective coating).

Request a Quote Back to category

Comments 0